S-B18 Automatic Double Dies Press Machine
S-B18 Automatic Strip Feed Press is built for small can end stamping. Piled strips are lifted by a set of hydraulic cylinders then suck pads send strip one by one to strip feeding station. (also can link with Automatic Strip Feeder S-B18-2M). Reciprocating feeding bar at feeding station push strip into punch tooling. Formed can end is ejected out via. end kickers (or air blowing) to rear while strip scrap is ejected out by a pressing roller to side. Equipped with dual dies. Punch tooling is made of alloy steel; hence, sturdy for long life. An automatic lubrication pump and multiple safety devices are equipped for easy maintenance and safe operation.
coming soon
Specifications
| Machine Type | S-B18 | |
|---|---|---|
| Strokes Per Min. | 200 - 301D Up to 300 st/min. 307 - 401D Up to 250 st/min. |
|
| Horse Power Required | Main Motor | 7.5HP |
| Hydraulic Pump | 2HP | |
| Vacuum Pump | 1/2HP | |
| Scrap Ejector | 1/4HP | |
| Air Compressor (Optional) | 1/2HP | |
| Range of Strip Length | 510 - 915mm | |
| Range of Strip Width | 128 - 220mm | |
| Max. Die Height | 250mm | |
| Floor Space Overall Height | 2500 x 3610 x 1850 mm | |
| Net Weight (approx.) | 4800 kgs | |
Features
- Strips lifting by hydraulic cylinder and use proximity switch for strips height control.
- With duplex switch for machine starting, safe and reliable
- With Air Clutch for power transmission, effective but low maintenance.
- Multi-safety design for machine and personnel safety.
- Easy for can size changeover and adjust.
- Can be connected with automatic strip feeder model S-B18-2M to save labor cost.
- With two mechanical end kicker to eject formed ends out.
- Double sheet detector is equipped for safe strip feeding.
Layout Dimension
