S-B18G Automatic Strip Feed Press is built not only for two piece can drawing but also for five gallon end stamping. Piled strips are lifted by a pair of hydraulic cylinders then suck pads send strip one by one to strip feeding station. (also can link with Automatic Strip Feeder S-B18-2). Reciprocating feeding bar at feeding station push strip into punch tooling. Formed can body or end is ejected out via. air blowing to rear while strip scrap is ejected out by a pressing roller to side. Punch tooling is made of alloy steel; hence, sturdy for long life. An automatic lubrication pump and multiple safety devices are equipped for easy maintenance and safe operation.
Range of Can Dia.
211 - 401D x 56mmH
Capacity Per Min.
Up to 100 EPM
Horse Power Required
10HP x 1, 1HP x 2 , 1/4HP x 1
Range of Strip Length
510 - 915mm
Range of Strip Width
128 - 260mm
Floor Space Overall Height
3610L x 2500W x 1850H mm
Net Weight (approx.)
Strips lifting by hydraulic cylinder and use proximity switch for strips height control.
With duplex switch for machine starting, safe and reliable
With Air Clutch for power transmission, effective but low maintenance.
Multi-safety design for machine and personnel safety.
Easy for can size changeover and adjust.
B18G special for can body drawing.
Double sheet detector is equipped for safe strip feeding.